spanning-tree mstp msti (on a port)

Syntax

• default spanning-tree mstp msti <1-63> cost

• default spanning-tree mstp msti <1-63> force-port-state enable

• default spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} cost

• default spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} force-port-state enable

• default spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} priority

• default spanning-tree mstp msti <1-63> priority

• no spanning-tree mstp msti <1-63> force-port-state enable

• no spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} force-port-state enable

• spanning-tree mstp msti <1-63> cost <1-200000000>

• spanning-tree mstp msti <1-63> force-port-state enable

• spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} cost <1-200000000>

• spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} force-port-state enable

• spanning-tree mstp msti <1-63> port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} priority <0-240>

• spanning-tree mstp msti <1-63> priority <0-240>

Command Parameters

<1-63>

Specifies the instance parameter.

cost <1-200000000>

Configures the path cost for the port

force-port-state enable

Enables MSTI learning for the port.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

priority <0-65535>

Configures the MSTP bridge priority. Allowed values are 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864, 40960,45056, 49152, 53248, 57344, 61440.

Default

None

Command Mode

GigabitEthernet Interface Configuration